Where I normally like to create development boards for microcontrollers on stripboard, sometimes there are ready made boards or kits available that simplify things. We will look at several of these that I have purchased and I will highlight features…
In this example we connect a MAx7219 8×8 LED matrix to our PIC 16F819 development board Here is a picture of the module, these are very common and available from many sites The connections are as follows MAX7219 Pin Pic16F819…
The USB Bit Whacker is a spectacular little development board featuring the PIC18F2553. Based on the work of Brian Schmalz, the UBW is a small board with a command interpreter for basic input and output control. When attached to a…
In a previous example we connected a 16×2 LCD to our development board and displayed text on it, in this example we use the 2 buttons on the board to display some text on the LCD There are 2 buttons…
In this example we connected an LCD to the LCD 1602 LCD connection on the Open18F4520 PIC evaluation development board from Waveshare. A simple example is to display some basic text on the LCD display. This is a picture of the…
In this example we keep the LCD shield connected to our Chipkit UNO and this time we will connect an LDR to A4, read the value in and display it on the LCD display I used an LDR breakout but…
In this example we connected an Arduino LCD shield to our Chipkit UNO and displayed some basic text. here is a typical example of this shield, its a low cost 16 x 2 LCD and is good for many projects,…
Whilst browsing some electronic sites looking at some of the development boards and kits that are available when I noticed the Chipkit UNO, this was advertised as being pin for pin compatible with arduino shields but used a Pic micro…
In this example we will connect a buzzer to our pic and then play a basic tune, we will use mikroC and the Sound library that is available. Here is the schematic Schematic Code The code was written in mikroC,…
In this example we connect an LCD to our PIC16F873 microcontroller Schematic Code Mplab X using the XC8 compiler requires lcd.h lcd header file [codesyntax lang=”c”] #define _XTAL_FREQ 4000000 #define RS RC0 #define EN RC1 #define D4 RC2 #define…
This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Read More